Week 30: Over the hill?

Stuff is getting done! We are at the stage where we can start to check items off the list as being completed. We also have several lists to work off of.  Much is left to be done.  We arrived Sunday morning to find Gypsy unwrapped. The hull was clear of paper and tape and plastic. The hull paint had been buffed and Gypsy looked gorgeous. Greeting us as the door was a list of tasks from Tom.  This list did not include the things that Tom had told us about last week. The list was long. One of the items: “fix the companion way hatch so it slides better.”  The hatch has always stuck a bit, and even reinstalled, it still did bind.   The solution:  remove the sea hood and the hatch and fix it. We decided that that could wait until Monday.  At least the caulk was still fresh – it’s easier to remove than when it’s fully cured.

Bill was overwhelmed by the project lists so he started on the mast. The spinnaker crane for the mast head was painted and he installed that. The only thing left on the mast is to wire the tri-color anchor light at the mast head and put the halyards back on.

The new spinnaker crane should work much better. We also got the mount for the new wind instrument added and the L.E.D. tri-color/anchor light installed.
The new spinnaker crane should put the spinnaker block out far enough in front that it won’t catch on the forestay. The block currently at the top will be replace with a larger, fully swiveling block.  Bill installed the mount for the new wind instrument and also added the L.E.D. tri-color/anchor.

While Bill was working on the mast, Nina was installing the lazarette lid. All of our cockpit locker lids are now installed. Next weekend we will paint them and the side decks with non-skid paint.  Now that we know how to tape them off, it should take one day to get that all done.

Complete, they just need non-skid paint and latches.
All the hatches installed –  they just need non-skid paint and latches.

Now that we were warmed up we were ready to tackle the stanchions, which ironically, were not on Tom’s list for us. They are the metal poles that hold the life lines. They actually went in very easily.

These stanchions are stout. The tubes are filled with a fiberglass tube and they have a brace added.
These stanchions are stout. The tubes are filled with a fiberglass tube and they have a brace added.

We rounded out the day by installing the new fore hatch, the aft dinghy tie down rings and the last port window.  That was 12 hours of work.

fore_hatch

On Monday it was time to work on the companionway hatch. We removed the sea hood, which was glued down really well and the hatch. Bill worked on the hatch and it still would not slide well. We asked Tom to look at it and he figured out where it was binding in no time at all. It now slides very well so we reinstalled it and the sea hood.

Next up was the bow cap. The bow cap not only protects the bow from the anchor, but it is where the forestay for the mast attaches. After lots of caulk and Nina stuck in the anchor locker tightening nuts upside down, it went on nicely.  The windlass went on next and will be used to haul the anchor in. It has an electric motor that was slightly fiddly to install but fit beautifully nonetheless. The wind-lass is very happy since she will no longer have to manually raise the anchor.

complete_bow
The completed bow. You can see the bow cap (upper left) and the windlass (center).

We then bolted the fuel tank in place. Now we are ready for the engine. Nina installed four of the rub strakes she had made last weekend, and with help from Bill, screwed in the exhaust fitting for the Espar heater. Bill installed the compass. That was 13.5 hours work. It was a long day and we both were very tired.

Bow rub strakes.
Bow rub strakes.
Stern rub strakes.
Stern rub strakes.

 

Advertisements

One thought on “Week 30: Over the hill?”

  1. I continue to be amazed at what you’re accomplishing! I think learning scales and arpeggios would be much easier! Cheers! You’re terrific!

    Like

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s